2014 Dodge Charger
Mileage
58,702
Service Date
12/13/2024
Services Performed
- *COUPON* ENGINE OIL AND FILTER SERVICE w/ COMPLIMENTARY INSPECTION
Rae M. gave our service a 5 star review on 12/13/2024
-
-
2004 Ford Focus
Mileage76,164Service Date11/19/2024Services Performed- Another shop has replaced the clutch master cylinder, the vehicle has the same symptoms from before it was changed. There is no pressure in the clutch hydraulic system. Attempted to bleed the system and identify issue. Found the slave cylinder to blow off pressure once air bubbles are removed. Found coolant dripping all over the back side of the engine as well. Pressurized cooling system and let it sit for 30 minutes to find leaks. No active coolant leaks found. Degreased and pressure washed engine and transmission to identify any other leaks or issues. No cooing system leaks found. While inspecting the vehicle, technicain found the inner tie rod on drivers side is bent. Recommend replacing both inner and outer tie rods to ensure safe driving conditions. The slave cylinder leaking warrants replacing the clutch as well due to clutch material being saturated with brake fluid. Recommend replacing all clutch related components and repair coolant leak. Inner tie rod was found to be bent also, recommend replacing all tie rods
- Removed transmission and clutch assembly. Removed flywheel to have resurfaced. Inspect rear main seal, no issues. There is a coolant leak at thermostat outlet and by pass hose on thermostat housing. Torqued flywheel back on and assembled clutch and pressure plate. Installed new slave cylinder/release bearing. Reinstalled transmission and all related components. Checked transmission oil condition and level. No adjustments needed. Bled clutch hydraulic system and verified clutch operation. Shifts through the gears well and no clutch/transmission related issues at this time.
- TIE RODS – INNER & OUTER – REMOVE AND REPLACE – BOTH SIDES
- Performed wheel alignment after all repairs. Rear camber is not adjustable as configured but is within factory tolerances. Test drive, steering wheel is level and vehicle tracks straight on the road.
- Found coolant leaking from thermostat housing and bypass hose. Drained coolant into clean catch pan to reuse. Removed thermostat water outlet and replaced gasket at thermostat and the bypass hose that was oil saturated and split open from over tightening clamp to hose. Vacuum filled cooling system with captured coolant.
Mike H. gave our service a 5 star review on 11/22/2024 -
2011 Honda Odyssey
Mileage135,010Service Date11/20/2024Services Performed- CUSTOMER STATES – CHECK ENGINE LIGHT IS ON & RUNNING ROUGH – P3497 – CHECK AND ADVISE
- Removed and replaced VVT oil control switch. Verified system is repairs and operational. Test drive and multiple key cycles to ensure the issue is resolved. No check engine light returned after repairs. Confirmed repair.
Larissa S. gave our service a 5 star review on 11/20/2024 -
2018 Subaru Forester
Mileage100,908Service Date10/16/2024Services Performed- Inspected entire vehicle and only thing that needs attention is the air filter is dirty. Vehicle is in great shape otherwise.
- Drained transmission oil and refilled using Subaru CVTF. Raised transmission temp to adjust fluid level. Vehicle drives great.
BRIAN B. gave our service a 5 star review on 10/23/2024 -
2011 Ford Taurus
Mileage185,066Service Date8/28/2024Services Performed- Removed wheels, removed rotors, pads, and calipers. Cleaned and greased brake caliper slip pins. Installed new pads, rotors, hardware. Removed both rear upper control arm bushings and pressed in new ones. NO CHARGE! THANK YOU FOR BEING OUR CUSTOMER.
- While brakes are removed, removed and replaced both front wheel bearing assemblies. Torqued all components to spec.
Shane M. gave our service a 5 star review on 9/4/2024 -
2014 Honda CR-V
Mileage45,676Service Date8/12/2024Services Performed- Drained oil and removed filter. Oil was very low, there is no signs of leakage from the engine. Regularly checking the oil level will increase engine life and health. Checked air filter, dirty, replaced. CHecked cabin filter, due next service. Valve adjustment is also due at next oil and filter service. Refilled with synthetic 0w20 oil and reset service reminder. All other components look great at this time.
Liz S. gave our service a 5 star review on 8/15/2024 -
2011 Ford Pickup
Mileage201,058Service Date6/25/2024Services Performed- Found the front right rotor extremely grooved but pad life to be ok. Someone has recently replaced pads but not the rotors. Also found the front left wheel bearing to have play and both front tires are cutting off on the inside. Recommend replacing both front wheel bearing assemblies, brake pads and rotors and performing a wheel alignment. Engine oil and transmission pans are both leaking heavily and customer is aware, front left axle seal is seeping and not a problem at this time.
- Removed front brakes, rotors and hub assemblies. Right inner dust capo is missing when arrived and left side is damaged and will not go into new hub. There are no new caps available locally at this time. We can get some and install them in the near future. Installed new bearing hub assemblies, coated brake rotors and high quality pads. Routed new wheel speed sensor harness in the proper manor. After rechecking front suspension was tight with the new wheel bearings, technician said now that the major issue is gone, the lower ball joints seem to have a minor amount of play. No immediate cause for concern.
- Rotated front tires with wear on inner edge of treads to the rear and better tread tires to the front. Torqued to spec. Performed wheel alignment as close to factory specs as possible. Some specs are not adjustable. Test drive. Brakes feel great, truck tracks straight and steering wheel is level.
Kaden L. gave our service a 5 star review on 7/11/2024 -
2021 Dodge Challenger
Mileage33,152Service Date6/13/2024Services Performed- Found inner pads on rear brakes worn out completely. Recommend replacing pads and rotors in rear immediately. Removed and replaced rear pads and rotors with new hardware and service slide pins. Torqued all components to spec and drove car to bed in new pads. Brakes feel great now and has no noise or pulls in either direction.
Miles M. gave our service a 5 star review on 6/13/2024 -
2023 Toyota GR Corolla
Mileage13,000Service Date5/16/2024Services Performed- WHEEL ALIGNMENT
Adam P. gave our service a 5 star review on 5/24/2024 -
2013 Dodge Charger
Mileage59,845Service Date4/29/2024Services Performed- With engine idling, technician listened to noise from front of engine with stethoscope. Heard noise from both idler pulleys. Recommend replacing belt, tensioner and both idler pulleys.
- SERPENTINE BELT TENSIONER & IDLER PULLEYS – Remove & Replace
BRIAN M. gave our service a 5 star review on 5/17/2024
